Fire and Flood Duct Restoration San Antonio, TX

Professional Fire and Flood Duct Restoration Services in San Antonio, TX

After storms and flash floods, ducts in low-lying properties often take on dirty water. Our technicians restore the ducts section by section. We start by inspecting the ducts with a camera to assess the soot, water, or debris inside. We coordinate with your insurance adjuster and restoration contractor when needed. Then we extract any standing water and dry the ductwork thoroughly. With the residue removed, we deodorize the ducts to neutralize smoke and musty odors. After restoration, we run the camera through the ducts again to confirm the results. The specific duct restoration services we handle for homes and businesses are listed below.

Fire Damage Duct Cleaning in San Antonio

Ducts near the fire zone take heat, flame contact, and thick soot that bakes onto metal surfaces. Our team cuts access ports into the affected trunk and branches and uses a camera to check for warped, melted, or burned sections. Metal ducts that kept their shape get cleaned with rotary brushes and contact cleaning tools, followed by soot-removing agents for baked-on residue. Sections with heat warping, melted flex duct, or burned liner get marked for replacement. We vacuum all loosened soot through a HEPA collection unit so none escapes into the home. The salvageable ductwork comes out clean, and damaged runs get scheduled for replacement.

Smoke Damaged Duct Cleaning in San Antonio

Smoke travels far beyond the fire, and a running system pulls it through every return and into ducts that serve undamaged rooms. San Antonio Air Duct Pro traces how far the smoke spread by checking each return and branch with a camera and soot wipe tests. Kitchen protein fires leave a sticky, nearly invisible film, while fires involving synthetic materials leave dark, oily soot, and each needs a different cleaning agent. Our air duct sanitization service team cleans each affected run with rotary brushes and the matched agent, then HEPA vacuum the residue. Registers and grilles get removed and washed in a degreasing solution. Rooms that never saw flames stop smelling of smoke once the ducts serving them are clean.

Duct Restoration After Fire in San Antonio

Once cleaning and inspection finish, some fire-damaged duct sections still need to be rebuilt before the system can run safely. Our HVAC system restoration pros remove warped metal sections, melted flex runs, and smoke-soaked insulation, then measure each opening for replacement. New rigid trunks and insulated flex branches go in to match the original layout and airflow. Every joint gets sealed with mastic and wrapped with fresh foil-faced insulation. The air handler connections get inspected and resealed so no smoke-damaged gasket remains. We coordinate the rebuild with your restoration contractor so new ducts go in before drywall and paint. A pressure test and airflow check confirm the rebuilt system works as it did before the fire.

Duct Deodorization After Fire in San Antonio

Smoke odor molecules soak into dust, gaskets, and porous duct surfaces, so the smell can return weeks after a cleaning if the odor goes untreated. Our duct fogging service treats smoke odor only after the ducts are fully cleaned, since deodorizing over soot just masks the smell. The crew fogs the duct system with an EPA-registered deodorizer labeled for HVAC use, which reaches every branch as the blower circulates it. For heavy odor, we run a hydroxyl generator that breaks down odor molecules while the home stays occupied. Gaskets and liner pieces that keep releasing odor get replaced. The smoke smell stays gone, and the system stops pushing odor into rooms each time it runs.

Water Damaged Air Duct Restoration in San Antonio

Roof leaks, burst pipes, and AC drain overflows soak ducts with relatively clean water, but wet insulation and duct board can start growing mold within a day or two. Our HVAC mold remediation crew finds every wet run with a moisture meter and thermal camera, including ducts hidden above ceilings. Wet insulation, flex duct, and duct board get cut out, since those materials hold water and cannot be dried reliably. Metal ducts get dried with air movers and treated with an EPA-registered antimicrobial. New insulated duct sections replace the removed materials, and every joint gets sealed. When the leak came from the AC drain or duct condensation, we repair that source too. The restored ducts stay dry, and the ceilings below stop staining.

HVAC Duct Restoration After Flood in San Antonio

Floodwater from storms or rising water counts as grossly contaminated water under IICRC S500 guidance, because it carries sewage, soil, and bacteria. Our team removes all ductwork that sat in floodwater, including floor ducts, crawl space runs, and any section below the flood line. Metal ducts above the flood line get inspected for wicking and condensation damage, then cleaned and sanitized. The air handler gets evaluated separately, and units that sat in floodwater usually need replacement for safety. New ductwork goes in after the structure dries and the restoration contractor clears the area. Your rebuilt duct system starts clean, with no flood residue left in the air path.

Duct Drying and Antimicrobial Treatment in San Antonio

Ducts that got damp but not soaked, such as runs near a leak or in a humid attic after a storm, can still grow mold if they stay wet. San Antonio Air Duct Pro measures moisture in duct walls and insulation and sets up air movers and dehumidifiers to dry the affected runs. Drying continues until readings fall to normal levels for each material. We then apply an EPA-registered antimicrobial labeled for HVAC use to the dried surfaces. Moisture readings get logged each day for your insurance file. Insulation that stays damp after drying gets replaced instead of sealed in. The ducts dry out before growth starts, which saves them from replacement.

Insulation and Duct Liner Replacement in San Antonio

Duct insulation and internal liner absorb soot, smoke odor, and water, and cleaning cannot pull those contaminants out of porous fibers. Our air duct replacement crew strips damaged insulation from duct exteriors and removes internal liner from metal trunks and plenums. Exposed metal gets cleaned and inspected for rust or corrosion before new materials go on. We wrap the ducts with new foil-faced insulation and seal every seam with UL 181 foil tape so the vapor barrier stays continuous. Plenums get relined with new duct liner or rebuilt with insulated duct board where the original design called for it. Removed materials get bagged and disposed of following restoration guidelines. The ducts hold temperature again and stop releasing odor or moisture.

Fire and Flood Duct Restoration Near Me in San Antonio, TX

Property owners searching for local duct restoration need a crew that responds quickly and works within insurance requirements. San Antonio Air Duct Pro serves San Antonio and nearby areas including Stone Oak, King William, and Southtown with fire, smoke, water, and flood duct restoration for homes and businesses. Call (210) 960-8514 to schedule an emergency assessment.